| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the lower anchor
bolt. |
| 3. |
Remove the following parts. (Refer to the Body
group- Interior trim)
|
| 4. |
Remove the upper anchor
bolt. |
| 5. |
Disconnect the Seat Belt Pretensioner
connector.
|
| 6. |
Loosen the Seat Belt Pretensioner mounting
bolt and remove the Seat Belt
Pretensioner. |
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Install the Seat Belt Pretensioner (BPT) with
a bolt.
Tightening
torque
Bolt B: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m,
28.9 ~39.8 lb.ft)
| |
| 4. |
Connect the Seat Belt Pretensioner (BPT)
connector. |
| 5. |
Install the upper anchor bolts.
Tightening
torque
: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9
~39.8 lb.ft)
| |
| 6. |
Install the following parts. . (Refer to the
Body group- Interior trim)
|
| 7. |
Install the lower anchor bolts.
Tightening
torque
: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9
~39.8 lb.ft)
| |
| 8. |
Reconnect the battery negative
cable. |
| 9. |
After installing the Seat Belt Pretensioner
(BPT), confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
